PLE DISPLAY version 1.1

Connect the display output cable to PC's serial port using the crossover adapter
Set Baud rate to 9600 bps, 8,N,1.
You will see "3RV      0" text scrolling down on HT window
Type HD followed by "Enter" key and the scrolling stops.
Now is ready to receive setup commands. After setup use again HD to go back in working mode.

	 VE 
	Report Version Report Version Number
	 

	 DU 
	Load Factory Default Values
	 

	 UD 
	Save Current Parameters settings in EEPROM
	 
	
	 SD 
	Set Dead band
	 

	 GD 
	Get Dead band
	 

	 ST 
	Set Timer value
	 

	 GT 
	Get Timer value
	 

	 SL 
	 Set backlight  (need HD to see result)
	 

	 SC 
	Set Contrast  (need HD to see result)
	 

	 GC 
	Get Contrast
	 

	 GL 
	Get Backlight
	 

	 PP 
	Display_input_Lplus Display position LIM(+)  ( display shows X> )
	 

	 PN 
	Display_input_Lminus Display position LIM(-)  ( display shows X< )
	 

	 PL 
	Display_input_Lboth (error condition) Display position LIM(+) LIM(-) or Tracking error
	When tracking error doesn’t end shutdown in "display mode" (RV mode)  Display shows "x?"
	 

	 PO 
	Display_input_Lnone Display position not on LIM
	 

	 NX 
	change Numerator X 
	 

	 DX 
	change Denominator X
	 

	 NY 
	change Numerator Y
	 

	 DY 
	change Denominator Y
	 

	 HD 
	Toggle HOLD Stop and start automatic mode
	 

	 GX 
	Get X Magnitude (X Magnitude = NX/DX the multiplication factor on X axis)
	 

	 GY 
	Get Y Magnitude (Y Magnitude = NY/DY the multiplication factor on Y axis)